|
Depth scale |
Tip Resistance |
Sleeve Friction |
Pore Pressure |
Pore Pressure |
Friction Ratio |
Inclination |
Project Table |
*Page Depth |
Report Qc Max |
Report Fs Max |
Report U Min |
Report U Max |
Report Friction Ratio Max |
Report Incl Max |
Default Value |
15 |
50 |
500 |
-100 |
1000 |
10 |
500 |
CPT - basic |
3 |
✓ |
✓ |
✓ |
✓ |
✓ |
|
CPT - Liquefaction Analysis |
3 |
✓ |
✓ |
✓ |
✓ |
✓ |
|
CPT - Parameters A3 |
3 |
✓ |
✓ |
✓ |
✓ |
✓ |
✓ |
CPT - Parameters A4 |
1 |
✓ |
|
✓ |
✓ |
✓ |
|
TG6_Draft2 |
2 |
✓ |
✓ |
✓ |
✓ |
✓ |
✓ |
*Page Depth is in the features table
Choose your values based on your data
Enter your data into the corresponding columns in the project table
Reload your report and check that no data get cut off
NOTES:
•In Project Table if the input entered is not an integer it will come up as an invalid input.
•For the pore pressure, ‘Report U Min’ cannot be above 0. If the value is above 0 it will default to 0. This will not be corrected in the database it will just be ignore.
•If the range between the Min and Max is less than the count value (number of lines in the graph) then the Max value will be Min +10 This will not be corrected in the database it will just be ignore.
•To avoid any rounding problem try and keep the range divisible by 10